Artikelnummer
215701

Brodit houder voor blikjes en flesjes 72mm gat

Prijs € 15,95
Ruim op voorraad
-
+
  • Snelle verzending
  • Producten van hoge kwaliteit
  • Veilige betalingen
Gegevens
Houder voor blikjes, flessen en thermomokken. Bevestig eenvoudig op het ProClip Montage Platform in uw auto. Ook perfect voor gebruik in vrachtwagens, boten, hot tubs etc. Gatdiameter 72 mm. Vervaardigd in ABS plastic. Zwarte.
Meer informatie
Meer informatie
Accessoiremerk Brodit
Barcode 7320282157012
Adviesverkoopprijs incl. BTW € 15,95
Houder Pasvormtype Toestelspecifiek
Toestel met of zonder hoes Zonder hoes
Kabel / Qi / lader type / connnector passive
Input Voltage n.v.t.
Voltage (output) n.v.t.
Max Amperage n.v.t.
Montage standaard AMPS
Afsluitbaar nee
Kleur zwart
Productinfo Brodit houder
Productinstallatie Brodit houder
Product geschikt voor info Brodit houder
Toon meer + Minder weergeven -
Compatibility
Toon meer + Minder weergeven -
Instructies
Please read all of the instructions and look at the pictures before attaching the holder. 1. To adjust the holder for your device: Loosen the screws on the front side of the holder, so the sides of the holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in place. Tighten the screws on the front side of the holder.
2.To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
4. The holder is in place.
Scroll to top